Nội dung

ME-430 INTRODUCTION TO COMPUTER AIDED DESIGN SHAFT DETAILED DRAWING Pro/ENGINEER Wildfire 2.0 Dr. Herli Surjanhata PREPARING THE SHAFT FOR DETAILED DRAWING Open shaft.prt, and make sure you have the saved view ISO_1. Create A Cosmetic Curve And An Axis Through The Curve Portion Of The Keyway From Insert pull down menu, select Cosmetic -> Sketch Click Done. 1 Select FRONT as sketching plane, then click Okay. Select Top in the SKET VIEW menu, and pick the TOP datum plane. Select the curved end of the sledgerunner keyway as a reference. Pick this curve for reference. 2 Sketch a circle as shown. Click . Create An Axis Thru The End Of Keyway , and pick the curved Click end of the sledrunner keyway. 3 CREATE A DETAILED DRAWING OF THE SHAFT Select the Create new object icon Choose Drawing from the New dialog box. Enter the name shaft. Uncheck the Use default template. Click OK button. Accept SHAFT.PRT as default model, and click Browse button to pick c.frm format. Select Open. Click OK button. 4 Create FRONT, TOP, RIGHT-SIDE, ISOMETRIC and Detailed views of the shaft as describe and shown below. Create The First FRONT View Of The Shaft Click shaft. to insert drawing view of the The message prompt to Select CENTER POINT fro drawing view, and pick a location near the middle left of the drawing – see Figure. The Drawing View dialog box opens. Under Model view names, select FRONT from the list. Click OK. Turn off the datums and coordinate system. , and click redraw. to Unlock the movement of drawing views. 5 Right-click the graphics area, and select Lock View Movement. Now the view can be moved to unlock or Or click lock the drawing views. Create A Projected RIGHT-SIDE View Of The Shaft Click the FRONT view, then right-click and select Insert Projection View. Pick a location to the right of the front view. Create A Projected TOP View Of The Shaft 6 Click the FRONT view, then right-click and select Insert Projection View. Pick a location to the top of the front view. Create A Scaled ISOMETRIC View Of The Shaft to insert Click drawing view of the shaft. Pick a location near the upper right-hand corner of the drawing. Under Model view names, select ISO_1 from the list. Click Apply. 7 Select Scale under Categories. Pick Custom Scale. Enter 0.5 as scale for view. Click OK. Create A Detailed View Of Snap Ring Groove 8 From Insert pull-down menu, select Drawing View -> Detailed. Pick a point on the top view in the center of the snap ring groove. Pick a point here. The boundary of the detailed view are defined with a spline. To sketch a spline, pick points around the center point to define the view boundary. Press middle mouse button to finish. Pick a location above the snap ring groove on the top view. The detailed view appears. Be sure to move the detailed view and notes to best location – see figure. 9 Define View Display Define view display to make sure that HIDDEN LINES will be printed for each drawing views. • • TOP, FRONT & DETAILED views will be displayed with hidden lines. RIGHT & ISOMETRIC views displayed with no hidden lines. 10